Exhaust Wrap LIBERRWAY Header Wrap Exhaust Heat Wrap for Exhaust Pipes Tap Kit for Car Motorcycle, 2"x50ft with 10 Stainless Ties and Gloves

I used it to wrap the exhaust on my Diesel heater on the boat. It works really well, seems to adhere to itself, and the fact that they included the clamps to hold it in place is really nice. I can run the heater full blast for hours and be able to bare hand the exhaust so knowing I won't die in a fire is nice.When working with it, wear gloves and when you're done immediately remove and wash the clothes you're wearing. Like any fiberglass product, it will shed fibers that will make you itch. If using indoors wear a respirator. Once it's installed it's pretty stable and you don't need to worry about it.I highly recommend if you're wrapping any hot pipes.

This was used to "patch" a previous wrap job that had come loose on the forward pipe (near the brake pedal) and to wrap the rear pipe again to we hope reduce the heat available to melt boots on this Suzuki Boulevard M90 with custom pipes. Wrap installed easily enough, can't imagine it would be any different with any other wrap. Liked that the roll came with gloves to use. Straps work OK, too, but are difficult to get tight. I'm sure there's a secret, but no instructions were included to assist. Perhaps a special tool is helpful for the straps? Don't know. Managed to make it work with needle nose pliers and sidecuts, but could have been better if we knew exactly what to do.

All good except for the gloves advertised. They did not come in the box.

Great value for a total of 50' fiberglass exhaust wrap. I used one roll on the exhaust on my pickup to help lower the temperature of the passenger side floorboard. What a difference as I wrapped a double layer in one four foot length. Product looks good with no defects in it while wrapping around exhaust pipe. As directed soak in water before use and use the supplier rubber gloves to keep the fiberglass fibers from flying around. Supplied stainless steel bands are a little tricky to use but work good.

Inexpensive, worked like it should. if you are one of those folks who gets itchy around fiberglass... wear gloves and long sleeves, as quite bit of small loose fibers will come free during the wrap process. half the roll was enough to wrap the old, dented and discolored pipes on my Ironhead (it does have mufflers, drag pipes all the way to the back will require more than just 1/2 a roll). The stainless ties work, but I'll probably end up replacing with stainless safety wire, as I can't seem to get them as secure as I like. Color is as pictured, a bronzish brown and really does look great. Going to use the remainder to wrap the Buell's headers as after 7 years the black from a major hot rod supplier has leached all it's color and turned white. This wrap did not leach any color onto my hands while wrapping... so hoping it will retain it's color. I'd happily recommend to a friend.

Era lo que esperaba

covered a hole in my turbocharger exhaust gas pipe on a 6.6 turbodiesel. I have driven a 1000 miles and the product is working well so far. Turbo has up to 1450 degree temps.

Wire ties aren’t the best, stays fairly loose but still holds just enough, and the edges fray. I put the product on about a mo th ago and have risen around on my motorcycle with it. Have not washed bike. So no water has come into play with the edges fraying. The outter edge that isn’t under any wrap is starting to fray like crazy and fall apart.