OCTOPUS Bearing Polaris RZR 800-S 800-4 800 Both sides Front & Rear Wheel Carrier Bearings 2010-2015

The rear bearing is almost 2 mm too thick to fit in the bearing carrier correctly. It gits in the bore but is too deep to accept the snap ring. I removed new bearing and measured with a caliper. Stock bearing is 40mm deep, this one is almost 42mm. It is a visible difference as seen in the pictures. Caused me to miss one of the big riding weekends for us. Very disappointed. Would leave negative stars if it was possible. Simply the bearing is wrong, even though listing states it would fit.

Fit like they should, I recommend in purchasing the greasers to add more grease. I was able to add about 18 pumps to each.

Returning these. I drove 3 hours for a ride with family and 2 hours into the ride the drivers side front fell apart. The other three have held up so far. Going to reorder a better brand and replace them all out. Not going through that again.

Fronts fit great rears best fit in the trash! They're too wide to fit the snap ring back in. Sent the company pictures of the measurement and they say according to the part number They're correct. Junk absolutely junk and poor business to deal with! I don't recommend buying these from this company save your money and buy from another better company!

Rear bearing is incorrect. It is too tall to fit into the knuckle and allow the snap ring to fit. Unless you are prepared to shave your snap ring down, do not purchase.

The rear bearings are too wide for my 2012 RZR 800s. Once pressed in there isn’t room for the snap ring.

Great for the money

Wish i read the reviews before i bought these. sent them back wont buy again.