Blue Transparent Case for BeagleBone Black Transparent by SB Components

Awesome !!!!!!, but before ordering check the dimension of BoX & Beaglebone Board

Good look and feel,though its very slightly and I repeat very slightly loose for the rev C.Still it keeps my BBB safe and sound so pretty happy with it.

Great Value for money. Good quality product. My BBB fits in perfectly!

Love it

Fits the BBB perfectly

Holds the board nicely in place even without screws. Cut-outs are perfect sizes and the little pin to push the buttons is useful.

Fits like a glove. I bought several, no regrets.

The cut-out for the micro-HDMI cable is way too small - I tried several cables I have, but none of them reaches deep enough to work, because it gets blocked by the casing (see the image).

This is the BBB equivalent of the Multicomp cases for the Raspberry Pi, and it's constructed about the same -- two-part shell, holes for all the relevant ports. It appears to be acrylic or polycarbonate (instead of the Multicomp's apparent polyethylene), which may make it a bit more brittle than those, but unless you're doing a lot of robotics or outdoor design work, this won't really be an issue.The GPIO access slots seem a bit high for the typical cape (most of which seem to be designed to go around the ethernet jack, not over it), but they're fine for jumper wires and also offer direct access to the FTDI header should you need it. The reboot and reset switches have their own paperclip holes and there are light conduits molded into the case for the status LEDs.There were a few minor mechanical issues. Seating the board properly is a bit of an issue; it won't be immediately obvious that it didn't quite work right until you go to plug in an HDMI cable and find the port didn't quite clear the edge of the case; it will eventually snap in correctly, but it seems like more work than it should be for something so trivial. The slots for screw mounts also seem a bit small; you may need some trial and error to find the right screw, and might still need double-sided tape if you're putting the case on a wall or the like.Basically, this is a fine no-frills case for the BBB, something that until recently was vanishingly hard to find compared with the RPi equivalent. If you're going to use a cape or two, though, you might want a low-profile case like the ones from LaserGoodies or  GeauxRobot  instead. GeauxRobot

I had to enlarge the hole for the microHDMI spocket. The microUSB connector was tight fit.